Welcome to the bigboi Help Centre

Your Source for Expert Advice, Troubleshooting, and Product Information

BlowR PRO+ MKII | How to sync your remote control

If you need to pair your remote with your BlowR PRO+ MKII (for example, after replacing it or performing a reset), follow the steps below to complete the process.

Step 1: Set the Power Switch to Remote Mode

Plug your unit into the mains power supply and turn the power switch to the ADJUSTABLE/REMOTE position.

Figure 1

Step 2: Press the Pairing Button on the Unit

Locate the remote control pairing button just above the nameplate on the front of the unit. Quickly tap this button twice in succession — you must do this within 2 seconds.

Figure 2

Step 3: Activate the Remote

Press the Power Start, + (Acceleration), and – (Deceleration) buttons on the remote control one after the other. This sends the pairing signal to the unit.

Figure 3 Figure 4

Now turn on the motor start switch to test if the remote is paired successfully.

Test all buttons on the remote. If they respond correctly, your pairing was successful. If not, repeat Steps 2 and 3.

Notes:

  • All bigboi BlowR PRO+ MKII units are pre-paired at the factory. You’ll only need to follow this process if replacing a remote or after a reset.

  • To unpair the current remote, press and hold the pairing button on the unit for 10 seconds. The receiver will clear the pairing history automatically.

Still need help?

If you're having trouble pairing your remote, contact our customer support team — we’ll get you sorted fast.

Updated on 18 Jun 2025