How to Use the Wet & Dry Vacuum Function on the SuckR PRO

The bigboi SuckR PRO is built for serious cleaning power — whether you’re sucking up dust or tackling a wet mess. Follow these steps to operate the wet & dry vacuum function efficiently.

1. Power On the SuckR PRO

• Insert the plug into the outlet.

• Turn the main power switch to position “I” to start the unit automatically (Pic.9).

• You can also control power using the included remote.

2. Using the Remote Control

• Press the on/off button (A) on the remote to power the unit (Pic.10).

• Choose from three speed settings: low, medium, and high.

3. Stopping the SuckR PRO

• To turn the unit off, press the main switch to "O" on the machine (Pic.9).

• You can also turn it off using the remote.

4. Remote Code Matching (if needed)

If the remote doesn’t respond or you’re using a new one:

• Turn the switch on the unit to position "I" (Pic.9).

• Press the setting button (S) on the unit twice (Pic.11).

• Then press the on/off button (A) on the remote (Pic.10).

• The unit will stop during matching. After 10 seconds, the remote should begin working again.

• Note: Each SuckR PRO is factory-matched with its remote, so you’ll typically only need this step when replacing or reprogramming remotes.

⚠️ Important Note

• The dust bag is for dry vacuuming only. Remove it before performing any wet vacuuming.

By following these steps, you’ll get the most out of your SuckR PRO’s vacuum functionality. For deeper cleaning, check out how to use the Extraction Function.

Need help? Reach out to our support team anytime.