Welcome to the bigboi Help Centre

Your Source for Expert Advice, Troubleshooting, and Product Information

WashR PRO | The male connector connected to the inlet port is leaking?

If the male connector attached to the inlet port of your WashR PRO is leaking, it’s usually due to a loose fitting or an incompatible connection. This can affect pressure performance and lead to unnecessary water wastage.

POSSIBLE CAUSE SOLUTION
Connector is not fully tightened Ensure the male connector is securely tightened onto the inlet port. Even a slight gap can cause leaking under pressure.
Incorrect connector used for modification If you've modified the setup, confirm that the connector is pressure washer-rated and fully compatible with the existing female inlet thread.
Worn or damaged threads on inlet port Inspect the inlet for signs of damage or cross-threading. Replace any parts that show signs of wear or damage.

If you've checked all of the above and the leak continues, your connector or inlet may need replacing.
👉 Contact the bigboi support team here

Updated on 24 Jun 2025

WashR PRO | The current surged high while the WashR is starting up
WashR PRO | The motor does not start when switched on