How to Install the Battery in Your SUCKR or BLOWR Remote

Correct battery installation is essential for your SUCKR or BLOWR remote to operate properly.

Installing the Battery

1. Open the battery compartment on the back of the remote.
2. Position the battery with the labelled positive (+) side facing upward, as shown in the image.
3. Slide one edge of the battery underneath the metal retaining contact highlighted in red.
4. Press the opposite edge down until the battery sits flat and securely inside the holder.
5. Refit the battery compartment cover.

Important: Make sure the metal contact sits against the edge of the battery and is not trapped underneath or bent out of position.

How to Confirm It Is Installed Correctly

Once the battery has been fitted correctly, the remote should display a steady green light.

If the green light does not remain steady:

• Remove the battery and check its orientation.
• Confirm that it is fully seated beneath the retaining contact.
• Check that the metal contact is touching the battery correctly.
• Reinstall the battery and test the remote again.

Use the correct battery type specified for your remote. The battery shown in the reference image is a LIR2032 3.6V rechargeable battery.